Select your country

MAXIMATOR Gas Boosters - General Informations

EN AT DE HU SI SK HR 


MAXIMATOR GAS BOOSTERS - GENERAL INFORMATIONS

MAXIMATOR Gas Boosters - General Informations

Send enquiry for this product!
General information: 

The MAXIMATOR high pressure boosters are suitable for the oil free compression of gases and air. Industrial gases like Argon, Helium, Hydrogen and Nitrogen can be compressed to operating pressures of 2,100 bar (30,000 psi), Oxygen to 350 bar (5,075 psi).

Air driven boosters are an efficient alternative instead of electrically driven products and can be used in explosionproof areas.

Overview:

Booster to 40 bar (580 psi)
Boosters to 100 bar (1,450 psi)
Boosters to 300 bar (4,350 psi)
Boosters to 600 bar (8,700 psi)
Boosters to 2,400 bar (36,000 psi)

Functional description:

The MAXIMATOR boosters’ operating principle is similar to a pressure intensifier. A large air piston is charged with low pressure (air piston (3)) and works on a small area with high pressure (hp piston (2)). The continuous operation is achieved by a pilot operated 4/2 way valve (spool (4)). The spool leads the drive air alternately on the upper and bottom surface of the air piston.

The spool is piloted through two 2/2 way valves (pilot valves (7)) which are mechanically actuated through the air piston in its end positions. The pilot valves charge and discharge the spool chamber. The hp piston supported by the check valves (inlet check valve and outlet check valve (1)) delivers the flow.

The outlet pressure is directly related to the set air drive pressure. According to the formulas indicated in the table with technical features of the boosters, the static end pressure can be calculated. At this pressure a force balance between drive section and gas section is achieved. The booster stalls when this end pressure is reached, and does not consume any further air.

A pressure drop at the high pressure side or a pressure increase at the drive side starts the booster automatically until the force balance is achieved again. Additionally the MAXIMATOR boosters can be switched on and off automatically through MAXIMATOR air pilot switches, contact gauges or external control devices.

Application and implementation:

As a result of the wide range of models it is possible to select the optimum booster for each application. Single stage, double acting or two stage boosters or a combination of these models can be used to achieve different operating pressures and flow capacities.

  • Pressure test with gas
  • Gas transfer
  • Gas recovery
  • Charging of nitrogen accumulators
  • Supply for isolating gas systems
  • Gas assisted injection moulding
  • CO2 foaming
  • Transfer of oxygen cylinders
  • Charging of breathing air bottles
  • Leak test


Send enquiry for this product!

MAXIMATOR GAS BOOSTERS - GENERAL INFORMATIONS




Thank you for your enquiry!
We will contact you in shortest time possible.

© Copyright 2024 Ulbrich Group
HomeProductsNewsDownloadVideoPartnersAbout usSitemapDisclaimerTerms & ConditionsCookiesISO CertificationQuality policyPrivacy Policy
Back on top
https://www.ulbrich-group.com/,https://dir.ulbrich.si/,eng
We use cookies that help us with statistics to make your experience here one of the best. If they are not to your taste, you can disable them. However, if you continue browsing the page without changing your settings, we will understand that you fully agree to the use of cookies.
Cookie settingsCONTINUE VIEWING THE PAGE
COOKIE SETTINGS

We also use cookies, which help us with statistics to make your experience here one of the best. But don't worry - they are homemade.
You can read more about this in the Notice about cookies, and you can turn them off or on below.




SAVE SETTINGS