ORDER A “CUSTOM BUILT” HYDRAULIC PUMP
“Assemble to Order” means you can choose a basic pump with gas, air or electric motor. Then select the proper valve, gauge, pressure control, motor control and reservoir. You get a two-stage pump that gives high oil volume for fast cylinder approach (and return with double-acting cylinders) in the first stage and high pressure in the second stage.
These motors start under full load and are suitable for operation up to 5,000 or 10,000 psi. The motor is 1 1⁄8 hp, 12,000 rpm, 115 or 230 volt (specify), 50/60 cycle A.C. single phase (25 amp draw at 115V.). With proper valve they can be used with single- or double-acting cylinders. Remote control available.
- 1 1/2 HP JET MOTOR, SINGLE & THREE-PHASE
Feature low noise level, moderate speed for long service and are ideal for fixed applications. Motor is 1 1⁄2 hp, 3,450 rpm, 115 or 230 volt, 50 or 60 cycle (specify), A.C. single phase with thermal overload switch. Can be used with single or double-acting cylinders and equipped with remote control. Also available in 230/460 volt, three-phase (specify).
NOTE: These do not start under full load unless valve is in “neutral” (requires open or tandem center valve) and are not recommended for frequent starting and stopping.
- 3 HP JET MOTOR, THREE-PHASE
Gives low noise level and long life due to its moderate operating speed. Ideal for fixed installations. Consists of basic 10,000 psi pump, jet pump motor: 3 hp, 3,450 rpm, 230/460 volt, 60 or 50 cycle (specify). A.C. threephase, with thermal overload switch. Equipped with internal and external relief valve. Will start under load.
This pump is ideal for use where electricity is unavailable or cannot be used. The 5,000 or 10,000 psi pump has a 3 hp air driven motor at 3,000 rpm (optimum performance based on 80 psi air pressure and 50 cfm at the pump). You can drive single- or double- acting cylinders with the correct valve.
NOTE: 80 psi air supply required to start under full load.
This version is perfect when electricity and air are unavailable. It is capable of continuous operation at full pressure. Consists of basic 10,000 psi pump, 4-cycle Briggs & Stratton “Diamond Edge” gasoline engine, developing 6 hp. As with all these pumps, this unit can be valved for use with either single- or doubleacting cylinders.
